First, is the wall load-bearing?
Not every wall holds up the house, but the ones that do are rarely obvious from the inside. Walls that run perpendicular to the floor joists above, walls that stack over a beam or wall below, and any wall near the center of the home are the usual suspects. Exterior walls are almost always load-bearing.
The reliable way to know is to look at the framing — from the attic, a basement, or a small inspection opening — and trace where the joists land. When the answer is unclear, a quick engineering review is far cheaper than opening the ceiling and finding out.
What the permit office will ask for
If the wall carries load, nearly every jurisdiction requires a permit and a stamped structural design. Reviewers expect a framing plan showing the new beam, post locations, connection hardware, and a load path down to the foundation, plus calculations that back up the beam and post sizes.
Non-bearing walls often still need a permit when electrical, plumbing, or ducts are relocated — the permit covers the trades, not the framing.
What a stamped package includes
A wall-removal scope may include demolition and framing drawings, beam and post sizing, connection details, and footing checks. Engineering documents are sealed where required by an appropriately licensed engineer. Deliverables and the estimated schedule are confirmed after reviewing the available information.


